Hitachi DZ GX5020A Owners Guide - Page 42

English 12/3 Recording using LED Light (for DZ-GX5080A only) You can use the LED light to illuminate a subject to be recorded in a dark place. 1 Press the e button during recording pause or recording. An icon will appear on the screen, and the LED light will glow. LED light icon 0:00:00 REM 3 0 MIN LED light FINE 8:0 0AM 2/10 /2007 2 Press the e button again. The LED light will go out. Note: • Pressing e will turn the LED light on and off alternately. • The LED light will go out if you perform the following: - Display the Disc Navigation screen - Start playback - Switch to demonstration mode • Recording with LED light on will shorten the battery life more than recording with LED light off. • Do not turn the LED light on with your eyes near it. Also, be sure not to look directly into the light emitting portion when the LED light is on: Doing so could cause visual disorder, such as decreased sight. And especially: Do not record small children at close-up distance with the LED light turned on. • Do not use the LED light while pointing at a driver in vehicle: Doing so could dazzle the driver, causing an accident. • Do not use the LED light in a place where there is flammable or explosive gas: Doing so could cause fire or explosion. • Do not block the light emitting portion when the LED light is turned on: Doing so could generate heat. • Do not display the LED light beam reflected on a mirror, etc. on TV screen: Doing so could cause burning of screen. • Once you press the e button to turn the LED light on, it will remain on until the e button is pressed again, which is different from the conventional flash. • When using the LED light for recording, set the distance to subject at no more than 4.9 feet (1.5 m). 42