IBM 887022X Maintenance Manual - Page 130
heat-conducting
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Lever open Figure 69. Microprocessor locking lever fully open c. Align the triangle icon on the microprocessor with the triangle icon on the socket and press the microprocessor gently into the socket. Attention: Make sure that the microprocessor is aligned correctly before you proceed. To avoid bending the pins on the microprocessor, do not use excessive force when pressing it into the socket. d. Close the locking lever to secure the microprocessor. Pressing gently on the top of the microprocessor while closing the latch helps ensure a good connection. 11. Install the heat sink: a. Remove the heat sink from its package and detach the protective cover from the bottom of the heat sink Attention: Do not disturb or contaminate the heat-conducting grease on the bottom of the new heat sink. Doing so damages its heat-conducting capability and exposes the new microprocessor to overheating. Captive screws Heat sink Protective cover Figure 70. Aligning the heat sink over the microprocessor b. Align the heat sink over the microprocessor; then, carefully set it down on top of the microprocessor. 120 xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide