IBM 887022X Maintenance Manual - Page 177
unplugging
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
4. Remove the PCI-X assembly from the I/O board: a. Remove any adapters and adapter separators that are installed (see "PCI and PCI-X adapters" on page 86), unplugging any necessary cables. Note: The illustrations in this document might differ slightly from the hardware being serviced. b. Remove the center plane by turning the two center plane thumbscrews to release it; then, carefully lift the center plane out of its socket and place it on a static-protective surface. c. Release the PCI-X assembly ( 1 ) from the I/O board ( 2 ) by sliding ( 3 ) the PCI-X assembly toward the rear of the server so that the five tabs ( 4 ) in the I/O board are released from the five notches ( 5 ) in the PCI-X assembly. d. Lift the PCI-X assembly off of the I/O board and set it on a safe, clean work surface. Note: The illustrations in this document might differ slightly from the hardware being serviced. e. Remove the screws attaching the Remote Supervisor Adapter to the I/O board: Chapter 6. FRU information (service only) 167