IBM 887022X Maintenance Manual - Page 195
translations
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
Light path card Complete the following steps to remove the light path card. Note: v Read "Installation guidelines" on page 79. v Read the safety notices at "Safety notices (multilingual translations)" on page 260. v Read "Handling static-sensitive devices" on page 80. 1. Turn off the server (see "Turning off the server" on page 10) and disconnect all power cords and external cables. 2. Remove the two front fans (see "Replacing and troubleshooting fans" on page 122). 3. Remove the front bezel (see "Removing and replacing the bezel" on page 83). 4. Open the cover (see "Opening the cover" on page 82). 5. Disconnect the light path cable from the center plane (see "Center plane connectors, jumpers and LEDs" on page 159). 6. From the front of the server, grasp the edge of the light path card, push it in slightly to release the catch mechanism, and then pull it out until it tilts downward. Note: The illustrations in this document might differ slightly from the hardware being serviced. 7. Inside the server, squeeze the Light Path card at the arrows to free it from the server. 8. Slide the card the rest of the way out of the server. 9. To replace the Light Path card, reverse the above steps. Chapter 6. FRU information (service only) 185