IBM 887022X Maintenance Manual - Page 180
Riser, Remote, Supervisor, Adapter, replacement
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
Riser card and Remote Supervisor Adapter replacement Complete the following steps to remove the riser card. Note: v Read "Installation guidelines" on page 79. v Read the safety notices at "Safety notices (multilingual translations)" on page 260. v Read "Handling static-sensitive devices" on page 80. 1. Turn off the server (see "Turning off the server" on page 10) and disconnect all power cords and external cables. 2. Remove the PCI brick from the server (see "PCI brick" on page 158) and place it on a clean work surface. 3. Remove the PCI-X assembly from the I/O board: a. Remove any adapters and adapter separators that are installed (see "PCI and PCI-X adapters" on page 86), unplugging any necessary cables. Note: The illustrations in this document might differ slightly from the hardware being serviced. b. Remove the PCI-X assembly from the I/O board: 1) Remove any adapters and adapter separators that are installed (see "PCI and PCI-X adapters" on page 86), unplugging any necessary cables. Note: The illustrations in this document might differ slightly from the hardware being serviced. 2) Remove the center plane by turning the two center plane thumbscrews to release it; then, carefully lift the center plane out of its socket and place it on a static-protective surface. 170 xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide