IBM 887022X Maintenance Manual - Page 46
Cable, Remote, Supervisor, Adapter, II-EXA
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Cable the Remote Supervisor Adapter II-EXA: This section provides the information needed to cable the Remote Supervisor Adapter II. Figure 17. Connect the RSA II-EXA breakout cable to the server 1. Connect the RSA II-EXA breakout cable ( 1 ) to the RSA II-EXA breakout port ( 2 ) on the server. 2. Connect the video cable from your video device to the video port on the Remote Supervisor Adapter. 3. Plug the USB connector on the RSA II-EXA breakout cable in to one of the USB ports on the rear of the server. ASM RS-485 connector USB connector Management connectors Figure 18. RSA II-EXA breakout cable 4. Complete the following steps to connect the Remote Supervisor Adapter II-EXA to the LAN: a. Connect one end of a Category 3 or Category 5 Ethernet cable to the Ethernet connector on the Remote Supervisor Adapter II-EXA. Connect the other end of the Ethernet cable to your network. b. Check the Remote Supervisor Adapter II-EXA Ethernet link and activity LEDs. The location of the LEDs are shown in the following illustration. 36 xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide