IBM 887022X Maintenance Manual - Page 174
PCI-X, board, replacement
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
PCI-X board replacement Complete the following steps to remove the PCI-X board. Note: v Read "Installation guidelines" on page 79. v Read the safety notices at "Safety notices (multilingual translations)" on page 260. v Read "Handling static-sensitive devices" on page 80. 1. Turn off the server (see "Turning off the server" on page 10) and disconnect all power cords and external cables. 2. Remove the PCI brick from the server (see "PCI brick" on page 158) and place it on a clean work surface. 3. Remove the PCI-X assembly from the I/O board: a. Remove any adapters and dividers that are installed (see "PCI and PCI-X adapters" on page 86), disconnecting any necessary cables. Note: The illustrations in this document might differ slightly from the hardware being serviced. b. Remove the center plane by turning the two center plane thumbscrews to release it; then, carefully lift the center plane out of its socket and place it on a static-protective surface. c. Release the PCI-X assembly ( 1 ) from the I/O board ( 2 ) by sliding ( 3 ) the PCI-X assembly toward the rear of the server so that the five tabs ( 4 ) in the I/O board are released from the five notches ( 5 ) in the PCI-X assembly. d. Lift the PCI-X assembly off of the I/O board and set it on a safe, clean work surface. 164 xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide