IBM 887022X Maintenance Manual - Page 221

Diagnostic error codes Note: In the following error codes, if xxx is 000, 195, or 197, do not replace a FRU. The description for these error codes are: 000 The test passed. 195 The Esc key was pressed to abort the test. 197 This is a warning error and may not indicate a hardware failure. For all error codes, replace/follow the FRU/Action indicated. Note: See Chapter 8, "Parts listing, Type 8870," on page 249 to determine which components are replaceable by the customer, and which components should be replaced by an IBM field service technician. Error code/symptom FRU/action 001-198-000 (Test Aborted) 1. Check error log for messages. 2. Run Quick Memory Test All Banks. 3. Reload system BIOS code and rerun the test. 001-250-000 (Test aborted) 1. Check error log for messages (see "Error logs" on page 65). 2. SMP board 001-250-001 (Failed SMP Expansion Board ECC) 1. Check error log for messages (see "Error logs" on page 65). 2. SMP board 1 (bottom). 001-250-002 (Failed SMP Expansion Board ECC) 1. Check error log for messages (see "Error logs" on page 65). 2. SMP board 2 (top). 001-250-099 (Failed SMP Expansion Board ECC) 1. Check error log for messages (see "Error logs" on page 65). 2. SMP board 1 (bottom) and 2 (top). 001-250-xxx (Test Failed) xxx of 001 = Bottom SMP board; xxx of 002 = Top SMP board; xxx of 099 = Bottom and Top SMP boards 1. Check error log for messages. 2. Run Quick Memory Test All Banks. 3. Rerun ECC test. 4. SMP board xxx. 001-292-000 (Core system: failed/CMOS checksum failed) Load BIOS defaults and rerun test. 001-xxx-000 (Failed core tests) 1. SMP board 2. I/O board 001-xxx-001 (Failed core tests) 1. SMP board 2. I/O board 005-xxx-000 (Failed Video test) I/O board 011-xxx-000 (Failed COM1 Serial Port test) 1. Center plane 2. I/O board 015-xxx-001 (Failed USB test) I/O board 015-xxx-015 (Failed USB external loopback test) I/O board Chapter 7. Symptom-to-FRU index 211