Oki ML591 MICROLINE Reference Manual - Page 102

Reassign Graphics Codes Command (IBM AGM/E) ߜ ML390 Turbo, ML391 Turbo ߜ ML590, ML591 Function ASCII Dec Hex Reassign Graphics ESC ? m n 27 63 m n 1B 3F m n Note: The IBM AGM emulation combines the IBM Proprinter emulation with Epson LQ graphics for special graphics applications. You can use this command to reassign any of the graphics modes to one of the graphics commands (ESC K, ESC L, ESC Y, or ESC Z). Parameter m This parameter designates which of the four commands you're redefining. Substitute one of the four letters-K (single density), L (double density), Y (high speed double density), or Z (quadruple density)-for m in the command. Parameter n This parameter designates the density of the mode you are reassigning to the redefined code. Substitute the appropriate value for the density you wish to select, as taken from the "Epson ESC * m Command - 8-Pin Graphics Density Codes for m Values (24-Pin Printers)" table in the previous command description. When you are ready to print a graphics pattern, send the redefined command, followed by the graphics data. Graphics Resolution Command (IBM) ߜ ML390 Turbo, ML391 Turbo ߜ ML590, ML591 Function Select Graphics Resolution/ Print ASCII ESC [ g n1 n2 m [data] Dec 27 93 103 n1 n2 m [data] Hex 1B 5D 67 n1 n2 m [data] This command sets the graphics resolution and prints the graphic data. Parameters n1 n2 Range 0 to 255. These parameters specify the number of dot columns according to the following formula: dot columns = n1 + (n2 * 256) +1 Parameter m This parameter specifies the horizontal resolution of the graphics according to the following table. 64 Chapter 7: Graphics Commands for 24-Pin Printers