Oki ML591 MICROLINE Reference Manual - Page 148
EAN 8 Bar Code Command s, Table 82: IBM/Epson Select EAN 8 Command
View all Oki ML591 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
n8 = 0: do not print readable characters Print UPC E Bar Code Command The command for printing a UPC E bar code is ESC DLE B m [data] where m designates the number of characters which will follow in the data. A check digit cannot be used with UPC E bar codes. EAN 8 Bar Code Command s EAN bar coding is a variation of UPC coding. EAN 8 encodes eight digits. The digits can be any ASCII character from 0 to 9 (48 to 57 Dec, 30 to 39 Hex). Select EAN 8 Bar Code Command The command for selecting EAN 8 is ESC DLE A m 0 1 n3 n4 n5 0 0 n8 EAN 8 Parameters n3 and n4 These parameters set the vertical length of the bars in 6/72", as calculated by the equation [(n3 x 10) + n4] x 6/72" where the total value must be less than or equal to 25. EAN 8 Parameter n5 This parameter sets the maximum width of one character in 1/144" increments as follows: Table 82: IBM/Epson Select EAN 8 Command - Maximum Character Widths for Parameter n5 Values (9-Pin Printers) Value of n5 1 2 3 4 5 6 7 Character Width 19/144" 26/144" 33/144" 40/144" 47/144" 54/144" 61/144" When calculating the width of the printout, you must take into consideration the left hand guard pattern, the center guard pattern and the right hand guard pattern. EAN 8 Parameter n8 This parameter sets whether or not the readable characters are printed. n8 = 1: print readable characters n8 = 0: do not print readable characters 110 Chapter 10: Bar Code Commands for 9-Pin Printers