Oki ML591 MICROLINE Reference Manual - Page 130

ESC 3 n Line Spacing Command for 24-Pin Printers (IBM/E) ߜ ML390 Turbo, ML391 Turbo ߜ ML590, ML591 Function IBM PPR Set Line Spacing to n/180" Not applicable Set Line Spacing to n/216" ASCII: ESC 3 n** Dec: 27 51 n Hex: 1B 33 n IBM AGM ASCII: ESC 3 n** Dec: 27 51 n Hex: 1B 33 n ASCII: ESC 3 n** Dec: 27 51 n Hex: 1B 33 n Epson ASCII: ESC 3 n Dec: 27 51 n Hex: 1B 33 n Not applicable ** In the IBM mode, the line spacing increment for the ESC 3 n command is controlled by the Set Vertical Unit commands described below. This command lets you control vertical movement in fine increments, which helps with the precise placement of graphics. In the IBM emulations, the increment of the line spacing set by this command is controlled by the Set Vertical Unit commands described below. The actual amount of movement is set by the value of parameter n which can vary, depending on the emulation: Table 63: IBM/Epson ESC 3 Command - Values of Parameter n Emulation IBM PPR Epson, IBM AGM Values of n 1 to 255 0 to 255 Whenever a value of zero is assigned to n, the line spacing command will be ignored. n/360-Inch Line Spacing Commands for 24-Pin Printers (IBM/E) ߜ ML390 Turbo, ML391 Turbo ߜ ML590, ML591 Function Set Line Spacing to n/360" IBM PPR ASCII: ESC % 8 n Dec: 27 37 56 n Hex: 1B 25 38 n Epson ASCII: ESC [ n Dec: 27 91 n Hex 1B 5B n or ASCII: ESC + n Dec: 27 43 n Hex: 1b 2b n These commands let you set the line spacing in 1/360" increments for precise placement of graphics. The actual amount of movement is set by the value of parameter n which can vary, depending on the emulation: 92 Chapter 9: Vertical Control Commands