Oki ML591 MICROLINE Reference Manual - Page 161
Table 98: IBM/Epson Select EAN 13 Command, Maximum Character Widths for Parameter n
View all Oki ML591 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Select EAN 13 Bar Code Command The command for selecting EAN 13 is ESC DLE A m 0 2 n3 n4 n5 0 0 n8 EAN 13 Parameters n3 and n4 These parameters set the vertical length of the bars in units of 15/180", as calculated by the equation [(n3 x 10) + n4] x 15/180" where the total value must be less than or equal to 25. EAN 13 Parameter n5 This parameter sets the maximum width of one character in 1/360" increments as follows: Table 98: IBM/Epson Select EAN 13 Command - Maximum Character Widths for Parameter n5 Values (24-Pin Printers) Value of n5 1 2 3 4 5 6 7 Character Width 35/360" 49/360" 70/360" 84/360" 105/360" 119/360" 140/360" When calculating the width of the printout, you must take into consideration the left hand guard pattern, the center guard pattern and the right hand guard pattern. EAN 13 Parameter n8 This parameter sets whether or not the readable characters are printed. n8 = 1: print readable characters n8 = 0: do not print readable characters Print EAN 13 Bar Code Command The command for printing EAN 13 bar codes is ESC DLE B m [data] where parameter m designates the number of characters which will follow in the data. If you wish to include a check digit, enter the ASCII character @ (64 Dec, 40 Hex) at the end of the data. Chapter 11: Bar Code Commands for 24-Pin Printers 123