Oki ML591 MICROLINE Reference Manual - Page 65
Table 23: IBM ESC V and ESC SP & Epson ESC SP Commands, Character Spacing in Inches
View all Oki ML591 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Intercharacter Spacing Commands (IBM/E/ML) Note: Intercharacter spacing can NOT be set in the HSD and bit image graphics modes. ߜ ML320 E/I, ML321 E/I ߜ ML320 Std., ML321 Std. ߜ ML320 Turbo, ML321 Turbo Function Set Intercharacter Spacing Values for n IBM ASCII: ESC V n Dec: 27 86 n Hex: 1B 56 n n = 0 to 11 Epson ASCII: ESC SP n Dec: 27 32 n Hex: 1B 20 n n = 0 to 255 ߜ ML520, ML521 ML ASCII: ESC N n Dec: 27 78 n Hex: 1B 4E n n = 0 to 11 ߜ ML390 Turbo, ML391 Turbo ߜ ML590, ML591 Function Set Intercharacter Spacing Values for n IBM ML590/591 Only: ASCII: ESC SP n Dec: 27 32 n Hex: 1B 20 n n = 0 to 255 Epson ASCII: ESC SP n Dec: 27 32 n Hex: 1B 20 n n = 0 to 255* * For the ML390 Turbo and ML391 Turbo, bit 7 is ignored. The standard spacing between characters is 3 dots columns. These commands are used to add additional spacing between characters, added to the right of each character. The value is expressed in dots; the number of dots per inch depends on the current print mode. The table below shows the amount of space added for each cpi setting. Table 23: IBM ESC V and ESC SP & Epson ESC SP Commands - Character Spacing (in Inches) Setting 10 cpi 12 cpi 15 cpi 17.1 cpi 20 cpi Amount of space added n/120" n/144" n/180" n/206" n/240" For example, to add 8/120" spacing to your printing at 10 cpi, use this BASIC command: LPRINT CHR$(27);"N";CHR$(8) 26 Chapter 3: Character Size & Spacing Commands