D-Link DXS-5000-54S Emulator - Page 1008

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Command Mode • Privileged EXEC • User EXEC Example The following is an example of the CLI display output for the command. (Routing)#show ipv6 pim interface Interface 0/1 Mode Sparse Hello Interval (secs 30 Join Prune Interval (secs 60 DR Priority 1 BSR Border Disabled Interface 0/21 Mode Sparse Hello Interval (secs 30 Join Prune Interval (secs 60 DR Priority 1 BSR Border Disabled Neighbor Count 1 Designated Router fe80::20a:f7ff:fe81:8ad9 The following message will be displayed if no interfaces are enabled for PIM. None of the routing interfaces are enabled for PIM. Display Parameters Interface Mode Hello Interval Join Prune Interval DR Priority BSR Border Neighbor Count Designated Router slot/port lndicates whether the PIM mode enabled on the interface is dense or sparse. The frequency at which PIM hello messages are transmitted on this interface. The default is 30 seconds. The join/prune interval for the PIM router. The interval is in seconds. The priority of the Designated Router configured on the interface. This field is not applicable if the interface mode is Dense. Identifies whether this interface is configured as a bootstrap router border interface. The number of PIM neighbors learned on this interface. This is a dynamic value and is shown only when a PIM interface is operational. The IP address of the elected Designated Router for this interface. This is a dynamic value and will only be shown when a PIM interface is operational. This field is not applicable if the interface mode is Dense. 1002