D-Link DXS-5000-54S Emulator - Page 840

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Display Parameters BGP Section: Routing Protocol Router ID Local AS Number BGP Admin Mode Maximum Paths Always Compare MED Maximum AS Path Length Fast Internal Failover Fast External Failover Distance Redistribution Prefix List In Prefix List Out Neighbors OSPFV3 Section: Routing Protocol Router ID OSPF Admin Mode Maximum Paths Distance Default Route Advertise Always Metric BGP. The router ID configured for BGP. The AS number that the local router is in. Whether BGP is globally enabled or disabled. The maximum number of next hops in an internal or external BGP route. Whether BGP is configured to compare the MEDs for routes received from peers in different ASs. Limit on the length of AS-PATHs that BGP accepts from its neighbors. Whether BGP immediately brings down a iBGP adjacency if the routing table manager reports that the peer address is no longer reachable. Whether BGP immediately brings down an eBGP adjacency if the link to the neighbor goes down. The default administrative distance (or route preference) for external, internal, and locally-originated BGP routes. The table that follows lists ranges of neighbor addresses that have been configured to override the default distance with a neighbor-specific distance. If a neighbor's address falls within one of these ranges, routes from that neighbor are assigned the configured distance. If a prefix list is configured, then the distance is only assigned to prefixes from the neighbor that are permitted by the prefix list. A table showing information for each source protocol (connected, static, RIP, and OSPF). For each of these sources the distribution list and route-map are shown, as well as the configured metric. Fields which are not configured are left blank. For OSPF, an additional line shows the configured OSPF match parameters. The global prefix list used to filter inbound routes from all neighbors. The global prefix list used to filter outbound routes to all neighbors. A list of configured neighbors and the inbound and outbound policies configured for each. OSPFv3. The router ID configured for OSPFv3. Whether OSPF is enabled or disabled globally. The maximum number of next hops in an OSPF route. The default administrative distance (or route preference) for intra-as, inter-as, and external OSPF routes. Whether OSPF is configured to originate a default route. Whether default advertisement depends on having a default route in the common routing table. The metric configured to be advertised with the default route. 834