D-Link DXS-5000-54S Emulator - Page 673

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Route Adds Route Deletes Unresolved Route Adds Invalid Route Adds Failed Route Adds Hardware Failed Route Adds Reserved Locals RIP Routes Unique Next Hops (High) NextHop Groups (High) ECMP Groups (High) ECMP Groups ECMP Routes Truncated ECMP Routes ECMP Retries Routes with n Next Hops route is a route that was not selected as the best route to its destination. Number of routes that have been added to the routing table. Number of routes that have been deleted from the routing table. Number of route adds that failed because none of the route's next hops were on a local subnet. Note that static routes can fail to be added to the routing table at startup because the routing interfaces are not yet up. The counter gets incremented in this case. The static routes are added to the routing table when the routing interfaces come up. Number of routes that failed to be added to the routing table because the route was invalid. A log message is written for each of these failures. Number of routes that failed to be added to the routing table because of a resource limitation in the routing table. Number of routes failed to be inserted into the hardware due to hash error or a table full condition. Number of routing table entries reserved for a local subnet on a routing interface that is down. Space for local routes is always reserved so that local routes can be installed when a routing interface bounces. Total number of routes installed by RIP protocol. Number of distinct next hops used among all routes currently in the routing table. These include local interfaces for local routes and neighbors for indirect routes. The value in parentheses indicates the highest count of unique next hops since counters were last cleared. Current number of next hop groups in use by one or more routes. Each next hop group includes one or more next hops. The value in parentheses indicates the highest count of next hop. Number of next hop groups with multiple next hops. The value in parentheses indicates the highest count of next hop groups since counters were last cleared. Number of next hop groups with multiple next hops. Number of routes with multiple next hops currently in the routing table. Number of ECMP routes that are currently installed in the forwarding table with just one next hop. The forwarding table may limit the number of ECMP routes or the number of ECMP groups. When an ECMP route cannot be installed because such a limit is reached, the route is installed with a single next hop. Number of ECMP routes that have been installed in the forwarding table after initially being installed with a single next hop. Current number of routes with each number of next hops. 7-43 clear ip route counters Reset to zero the IPv4 routing table counters reported in the show IP route summary. If no router is specified, the command is executed for the default router. The command only resets event counters. Counters that report the current state of the routing table, such as the number of routes of each type, are not reset. 667