D-Link DXS-5000-54S Emulator - Page 1104

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide no timers bgp Parameters keepalive holdtime The time, in seconds, between BGP KEEPALIVE packets sent to a neighbor. The range is from 0 to 65,535 seconds. Jitter is applied to the keepalive time. The time, in seconds, that BGP continues to consider a neighbor to be alive without receiving a BGP KEEPALIVE or UPDATE packet from the neighbor. If no KEEPALIVE is received from a neighbor for longer than the hold time, BGP drops the adjacency. lfthe hold time is set to 0, then BGP does not enforce a hold time and BGP does not send periodic KEEPALIVE messages. The range is from 0 to 65,535 seconds. Default The default keepalive time is 30 seconds. The default hold time is 90 seconds. Command Mode • BGP Router Config • IPv4 VRF Address Family Config 11-105 timers policy-apply delay This command configures the delay after which any change to the global or per BGP neighbor inbound/ outbound policies are applied. Whenever policies (route-maps/prefix-lists/as-path-lists) or neighbor attributes like send-community, remove-private-asn etc. are modified by the user, the policies are scheduled to be applied after the current delay timeout. Whenever the delay is configured by the user, the pending polic ges if any are rescheduled with the new delay if the previous delay timeout is not expired yet. Configuring the delay with the value of 0 seconds means, the changes are applied immediately. For any change in the outbound policies applicable to a neighbor, the WITHDRAW packets are sent followed by the UPDATE packets when they are applied after the delay timeout. In case of changes to other neighbor attributes like send-community, remove-private-asn etc, the WITHDRAW packets are not sent-instead, the new UPDATEs are sent after the delay timeout. Use the no command to set to the default the delay after which any change to the global or per BGP neighbor inbound/outbound policies are applied. timers policy-apply delay delay no timers policy-apply delay Parameters delay The time. in seconds, after which the global or per neighbor policies are applied. The range is 0 to 180 seconds. 1098