D-Link DXS-5000-54S Emulator - Page 1098

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide The distribute-list out command can also be used to filter redistributed routes by prefix. Either a redistribute route map or a distribute list may be configured, but not both. A default route cannot be redistributed unless the "default-information originate" command is given. If a route map is configured, match as-path and match community terms are ignored. If no route map is configured with the name given, no prefixes are redistributed. Use the no command to remove the configuration for the redistribution for BGP protocol from the specified source protocol/routers. The command no redistribute ospf match external 1 will withdraw only OSPF external type 1 routes, ospf inter routes will still be redistributing. redistribute {ospf | rip | connected | static} [metric metric-value] [match {internal | external 1 | external 2 | nssa-external 1 | nssa-external 2}] [route-ma map-tag] no redistribute {ospf | rip | connected | static} [metric metric-value] [match {internal | external 1 | external 2 | nssa-external 1 | nssa-external 2}] [route-ma map-tag] Parameters ospf |connected | static metric metric-value match route-map map-tag A source of routes to redistribute. (Optional) When this option is specified, BGP advertises the prefix with the Muiti Exit Discriminator path attribute set to the configured value. If this option is not specified, but a default metric is configured for BGP, the MED is set to the default metric. If a default metric is not configured, the prefix is advertised without a MED attribute. (Optional) If you configure BGP to redistribute OSPF routes, BGP by default only redistributes internal routes (OSPF intra-area and inter-area routes). Use the match option to configure BGP to also redistribute specific types of external routes, or to disable redistribution of internal OSPF routes. (Optional) A route map can be used to filter redistributed routes by destination prefix using a prefix list. A route map can be used to set attributes on redistributed routes. Default The default is BGP does not distribute routes. When BGP redistributes OSPF routes, it redistributes only internal routes unless the match option specifies external routes. Command Mode IPv4 VRF Address Family Config 11-99 redistribute (IPv6 Address Family Config) This command configures BGP to non-BGP routes from the lPv6 routing table. The distribute-list out command can also be used to filter redistributed routes by prefix. Either a redistribute route map or a distribute list may be configured, but not both. A default route cannot be redistributed unless the "default-information originate" command is given. 1092