D-Link DXS-5000-54S Emulator - Page 663

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide 10.0.0.0 0.255.255.255 area 1 192.168.75.0 0.0.0.255 area 2 Distance Intra 110 Inter 110 Ext 110 Default Route Advertise Disabled Always FALSE Metric Not configured Metric Type External Type 2 Redist Source ---------static connected Metric ----default 10 Metric Type ---------2 2 Subnets ---------Yes Yes Dist List ---------None 1 Number of Active Areas 3 (3 normal, 0 stub, 0 nssa) ABR Status Yes ASBR Status Yes Display Parameters BGP Section: Routing Protocol Router ID Local AS Number BGP Admin Mode Maximum Paths Always Compare MED Maximum AS Path Length Fast Internal Failover Fast External Failover Distance Redistribution BGP Router ID configured for BGP. AS number that the local router is in. Indicates whether BGP is globally enabled or disabled. Maximum number of next hops in an internal or external BGP route. Indicates whether BGP is configured to compare the Multi-Exit Discriminators (MEDs) for routes received from peers in different ASs. Limit on the length of AS-PATH that BGP accepts from its neighbors. Indicates whether BGP immediately brings down an iBGP adjacency if the routing table manager reports that the peer address is no longer reachable. Indicates whether BGP immediately brings down an eBGP adjacency if the link to the neighbor goes down. Default administrative distance (or route preference) for external, internal, and locally-originated BGP routes. The table that follows lists ranges of neighbor addresses that have been configured to override the default distance with a neighbor-specific distance. If a neighbor's address falls within one of these ranges, routes from that neighbor are assigned the configured distance. If a prefix list is configured, then the distance is only assigned to prefixes from the neighbor that are permitted by the prefix list. Table showing information for each source protocol (connected, static, and OSPF). For each of these sources the distribution list and routemap are shown, as well as the configured metric. Fields which are not configured are left blank. For OSPF, an additional line shows the configured ospf match parameters. 657