D-Link DXS-5000-54S Emulator - Page 395

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide plane (hardware). Based on the figure, the approximate desired output when 512bytes packets are used can be calculated. 5-319 storm-control broadcast Enable broadcast storm recovery mode for all or specific interfaces (Global Config mode/Interface Config mode). If enabled, broadcast storm recovery is active and, if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. No command disables broadcast storm recovery mode for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode). storm-control broadcast no storm-control broadcast Parameters None Default The default is Disabled. Command Mode • Global Config • Interface Config 5-320 storm-control broadcast action This command configures the broadcast storm recovery action to either shutdown or trap for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode). If configured to shutdown, the interface that receives the broadcast packets at a rate above the threshold is diagnostically disabled. If set to trap, the interface sends trap messages approximately every 30 seconds until broadcast storm control recovers. Use the no command to configure the broadcast storm recovery action option to the default value for all interfaces (Global Config mode) or one or more interfaces (lnterface Config mode). storm-control broadcast action {shutdown | trap} no storm-control broadcast action Parameters shutdown trap Default The default is None. Enter the storm-control action to shutdown. Enter the storm-control action to trap. 389