D-Link DXS-5000-54S Emulator - Page 293

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide 0/49 DQS-5000-54SQ28 8 3 Serial Number A7N2018414 Part Number ----------AXM761 Nominal Bit Rate [Mbps 10300 Rev ----10 Display Parameters Port Vendor Name Link Length 50um Link Length 62.5um Serial Number Part Number Nominal Bit Rate Rev Indicates the interface port. The full name of listed corporation, suggested: abbreviation of corporation name, SCSI company code, or the stock exchange symbol. The name is 1 to 16 ASCII characters in length. The supported link length while operating in compliance with applicable standards using 50 micron multimode OM2 [500 MHz * km at 850nm] fiber. A value of zero designates no support for 50 micron multimode fiber or that the length information must be determined from the transceiver technology. The link length as supported by the transceiver while operating in compliance with applicable standards using 62.5 micron multimode OM1 [200 MHz * km at 850nm, 500 MHz * km at 1310nm] fiber. A value of zero designates no support for 62.5 micron multimode fiber or that the length information must be determined from the transceiver technology. The serial number for the transceiver. The serial number is 1 to 16 ASCII characters in length. A zero value in the field indicates an unspecified vendor serial number. The vendor part number or product name. A zero value in the field indicates an unspecified vendor serial number The nominal bit (signaling) rate in 100 MBd--rounded off to the nearest 100 MBd. The bit rate includes those bits necessary to encode and delimit the signal as well as those bits carrying data information. A zero value indicates an unspecified bit rate to be determined from the transceiver technology. The actual information transfer rate is dependent on the encoding of the data, as defined by the encoding value. Vendor product revision number. An empty field indicates that the vendor revision is unspecified. Remote Monitoring Commands Remote Monitoring (RMON) allows for the collection of network traffic data. RMON supports 64-bit counters (RFC 3273) and High Capacity Alarm Table (RFC 3434). Note: No configuration commands are available for ether stats and high capacity ether stats. The data source for ether stats and high capacity ether stats are configured during initialization. 5-189 rmon alarm Set the RMON alarm entry in the RMON alarm MIB group. 287