D-Link DXS-5000-54S Emulator - Page 774

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Default Route Advertise Disabled Always False Metric Not configured Metric Type External Type 2 Number of Active Areas 1 (1 normal, 0 stub, 0 nssa) ABR Status Disable ASBR Status Disable Stub Router FALSE Stub Router Status Inactive Stub Router Reason reason> Stub Router Startup Time Remaining duration> seconds Stub Router Duration duration> External LSDB Overflow FALSE External LSA Count 0 External LSAChecksum 0 AS_OPAQUE LSA Count 0 AS_OPAQUE LSA Checksum 0 New LSAs Originated 55 LSAs Received 82 LSA Count 1 Maximum Number of LSAs 24200 LSA High water Mark 9 AS Scope LSA Flood List Length 0 Retransmit List Entries 0 Maximum Number of Retransmit Entries 96800 Retransmit Entries High water Mark 1 NSF Helper Support Always NSF Helper Strict LSA Checking Enabled Prefix-suppression Disabled Display Parameters Note: Some of the information below displays only if you enable OSPF and configure certain features. Router ID OSPF Admin Mode RFC 1583 Compatibility External LSDB Limit Exit Overflow Interval Spf Delay Time Spf Hold Time Flood Pacing Interval 32-bit integer in dotted decimal format identifying the router, about which information is displayed. Shows whether the administrative mode of OSPF in the router is enabled or disabled. Indicates whether 1583 compatibility is enabled or disabled. Maximum number of nondefault AS-external-LSA (link state advertisement) entries that can be stored in the link-state database. Number of seconds after entering overflow state that a router will attempt to leave overflow state. Number of seconds between two subsequent changes of LSAs, during which time the routing table calculation is delayed. Number of seconds between two consecutive SPF calculations. Average time, in milliseconds, between LS Update packet transmissions 768