D-Link DXS-5000-54S Emulator - Page 1044

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide 11-23 default metric Use this command to set the value of the Multi Exit Discriminator (MED) attribute on redistributed routes (either BGP, IPv4 VRF, or IPv6 routes, depending on the mode) when no metric has been specified in the command "redistribute (BGP Router Config)". Use the no command to delete the default for the metric of redistributed routes. default-metric vulue no default-metric Parameters vulue The value to set as the MED. The range is 1 to 4,294,967,295. Default The default is as follows: metric is not set and MED is not included in redistributed routes. Command Mode • BGP Router Config • IPv4 VRF Address Family Config • IPv6 Address Family Config Config 11-24 default-originate (BGP Router Config) To configure BGP to originate a default route to a specific neighbor, use the neighbor default-originate command in BGP router configuration mode. By default, a neighbor-specific default has no MED and the Origin is IGP. Attributes may be set using an optional route map. A neighbor-specific default is only advertised if the Adj-RIB-Out does not include a default learned by other means, either from the "defaultinformation originate" command or a default learned from a peer. This type of default origination is not conditioned on the presence of a default route in the routing table. This form of default origination does not install a default route in the BGP routing table (it will not appear in the "show ip bgp" command), nor does it install a default route in the Adj-RIB-Out for the update group of peers so configured (it will not appear in the "show ip bgp neighbors advertised-routes" command). Origination of the default route is not subject to a prefix filter configured with the command "distribute-list prefix out". A route map may be configured to set attributes on the default route sent to the neighbor. if the route map includes a match ip-address term, that term is ignored. lfthe route map includes match community or match as-path terms, the default route is not advertised. lfthere is no route map with the route map name given, the default route is not advertised. Issue this command in Peer Template Configuration Mode to add it to a peer template. Use the no command to prevent BGP from originating a default route to a specific neighbor. default-originate [route-map map-name] no default-originate 1038