D-Link DXS-5000-54S Emulator - Page 35

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Parameters ipv6-address Indicates the IPv6 address of the neighbor or interface. Default The default is None. Command Mode Privileged EXEC 4-16 network ipv6 neighbor This command is used for the manual addition of IPv6 neighbors to the IPv6 neighbor table for this network port. The entry is automatically converted to a static entry if an IPv6 neighbor already exists in the neighbor table. Also, the neighbor discovery process does not result in static entries being modified. Such entries are, however, treated in the same manner for IPv6 forwarding. Furthermore, when the corresponding interface is operationally active, static IPv6 neighbor entries are applied to both the kernel stack and to the hardware. The no command is used for the removal of IPv6 neighbors from the neighbor table. network ipv6 neighbor ipv6-address macaddr no network ipv6 neighbor ipv6-address macaddr Parameters ipv6-address Default The default is None. Command Mode Privileged EXEC Indicates the IPv6 address of the neighbor or interface. 4-17 network ipv6 address When working with the network port, the options of this command can be used to configure the IPv6 global address manually, to enable/disable stateless global address autoconfiguration, and to enable/disable DHCPv6 client protocol information on the port. It is possible to configure multiple IPv6 addresses on the network port. The no command can be used to remove any configured IPv6 prefixes. When used with the address option, the command removes the manually configured IPv6 global address on the network port interface The command can also be used with the autoconfig option in order to disable the stateless global address autoconfiguration on the network port. Finally, the command can also be used with the DHCP option in order to disable the DHCPv6 client protocol on the network port. 29