D-Link DXS-5000-54S Emulator - Page 45

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide hostname ipv6 initTtl initTtl maxTtl maxTtl maxFail maxFail interval interval count count port port size size source {ip-address | ipv6address | unit/slot/port} The value for the hostname value should be a valid hostname. (Optional) The use of the optional ipv6 keyword before the ipv6-address or hostname is possible. If the ipv6 keyword is used before the hostname, the system will try to resolve to an IPv6 address. (Optional) The initTtl term is used to specify the initial time-to-live (TTL), which is the maximum number of router hops allowed between the local and remote system. The allowable values range from 0 to 255. (Optional) The maxTtl term is used to specify the maximum TTL. The allowable values range from 1 to 255. (Optional) The maxFail term is used to terminate the traceroute after failing to receive a response for the specified number of consecutive probes. The allowable values range from 0 to 255. (Optional) The optional interval parameter can be used to specify the time between probes, in seconds. In the event that a response is not received within the interval indicated, then the traceroute will consider that probe a failure (printing *) and send the next probe. If the traceroute does receive a response to a probe within the indicated interval, then it will immediately send the next probe. The allowable values range from 1 to 60 seconds. The optional count parameter can be used to specify the number of probes to be sent for each TTL value. The allowable values range from 1 to 10 probes. The optional port parameter can be used to specify the destination UDP port of the probe, which should consist of an unused port on the remote destination system. The allowable values range from 1 to 65535. The optional size parameter can be used to specify the size, in bytes, for the payload of the Echo Requests sent. The allowable values range from 0 to 39906 bytes. The optional source parameter can be used to specify the source IP address or the interface for the traceroute. Default • count: 3 probes • interval: 3 seconds • size: 0 bytes • port: 33434 • maxTtl: 30 hops • maxFail: 5 probes • initTtl: 1 hop Command Mode Privileged EXEC Example Some examples of the CLI command are shown below. traceroute Success: (Routing)# traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port 33434 size 43 39