D-Link DXS-5000-54S Emulator - Page 793

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide If an IP address is not specified, a table with the following columns displays for all neighbors or the neighbor associated with the interface that you specify. Router ID Priority IP Address Interface State Dead Time 4-digit dotted-decimal number of the neighbor router. OSPF priority for the specified interface. The priority of an interface is a priority integer from 0 to 255. A value of'0' indicates that the router is not eligible to become the designated router on this network. IP address of the neighbor. Physical routing interface or VLAN routing interface of the local router in slot/port format. State of the neighboring routers. Possible values are: • Down - lnitial state of the neighbor conversation; no recent information has been received from the neighbor. • Attempt - No recent information has been received from the neighbor but a more concerted effort should be made to contact the neighbor. • lnit - An Hello packet has recently been seen from the neighbor, but bidirectional communication has not yet been established. • 2 way - Communication between the two routers is bidirectional. • Exchange start - The first step in creating an adjacency between the two neighboring routers, the goal is to decide which router is the master and to decide upon the initial DD sequence number. • Exchange - The router is describing its entire link state database by sending Database Description packets to the neighbor. • Loading - Link State Request packets are sent to the neighbor asking for the more recent LSAs that have been discovered (but not yet received) in the Exchange state. • FuIl - The neighboring routers are fully adjacent and they will now appear in router-LSAs and network-LSAs. Amount of time, in seconds, to wait before the router assumes the neighbor is unreachable. 7-194 show ip ospf range Display the set of OSPFv2 area ranges configured for a given area for the specified virtual router. If no router is specified, it displays information for the default router. show ip ospf range areaid [vrf vrf-name] 787