D-Link DXS-5000-54S Emulator - Page 828

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Parameters backoff-multiple max-multicast-solicits max-unicast-solicits Sets the exponential backoff multiple to calculate time outs in NS transmissions during NUD. The value ranges from 1 to 5. 1 is the default. The next timeout value is limited to a maximum value of 60 seconds if the value with exponential backoff calculation is greater than 60 seconds. Sets the maximum number of multicast solicits sent during Neighbor Unreachability Detection. The value ranges from 3 to 255. 3 is the default. Sets the maximum number of unicast solicits sent during Neighbor Unreachability Detection. The value ranges from 3 to 10. 3 is the default. Default The default is None. Command Mode Global Config 8-33 ipv6 prefix-list This command is used in the Global Configuration mode to create a prefix list or to add a prefix list entry. Prefix lists allow route prefixes to be matched with those specified in the prefix list, with each such list including a sequence of prefix list entries that are ordered by their sequence numbers. Each prefix list entry is sequentially examined by a router to determine if the route's prefix matches that of the given entry. A nonexistent or empty prefix list permits all prefixes. An implicit denial is assumed in the event that a given prefix does not match any of the entries in a prefix list. Once a match or denial occurs, the router does not continue examining the rest of the list. A maximum of 128 prefix lists may be configured. In each prefix list, the maximum number of statements allowed is 64. The no command deletes a given prefix list or a statement within a prefix list. More specifically, the command no ip prefix-list list-name deletes the entire prefix list in question. Meanwhile,, you must specify a statement exactly, with all its options, in order to remove that individual statement from a prefix list. ip prefix-list list-name ([seq number] {permit | deny} ipv6-prefix/prefix-length [ge length] [le length] | renumber renumber-interval first-statement-number} no ipv6 prefix-list list-name [seq number] {permit | deny} ipv6-prefix/prefix-length [ge length] [le length] Parameters list-name seq number The text name of the prefix list Up to 32 characters. (Optional) The sequence number for this prefix list statement. Prefix list statements are ordered from lowest sequence number to highest and applied in that order. If you do not specify a sequence number, the system will automatically select a sequence number five larger than the last sequence number in the list. Two statements may not be configured 822