D-Link DXS-5000-54S Emulator - Page 1099

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide If a route map is configured, match as-path and match community terms are ignored. If no route map is configured with the name given, no prefixes are redistributed. Use the no command to remove the configuration for the redistribution for BGP protocol from the specified source protocol/routers. The command no redistribute ospf match external 1 will withdraw only OSPF external type 1 routes, ospf inter routes will still be redistributing. redistribute {ospf | rip | connected | static} [metric metric-value] [match {internal | external 1 | external 2 | nssa-external 1 | nssa-external 2}] [route-ma map-tag] no redistribute {ospf | rip | connected | static} [metric metric-value] [match {internal | external 1 | external 2 | nssa-external 1 | nssa-external 2}] [route-ma map-tag] Parameters ospf |connected | static metric metric-value match route-map map-tag A source of routes to redistribute. (Optional) When this option is specified, BGP advertises the prefix with the Muiti Exit Discriminator path attribute set to the configured value. If this option is not specified, but a default metric is configured for BGP, the MED is set to the default metric. If a default metric is not configured, the prefix is advertised without a MED attribute. (Optional) If you configure BGP to redistribute OSPF routes, BGP by default only redistributes internal routes (OSPF intra-area and inter-area routes). Use the match option to configure BGP to also redistribute specific types of external routes, or to disable redistribution of internal OSPF routes. (Optional) A route map can be used to filter redistributed routes by destination prefix using a prefix list. A route map can be used to set attributes on redistributed routes. Default The default is BGP does not distribute routes. When BGP redistributes OSPF routes, it redistributes only internal routes unless the match option specifies external routes. Command Mode IPv6 Address Family Config Example The routes obtained from the kernel can be configured to redistributed in the kernel. The following CLI commands (in both IPv4 and Pv6) BGP Router mode use the kernel option. (Routing)(Config)#router bgp 65401 (Routing)(Config-router)#redistribute ? connected kernel ospf rip static Press enter to execute the command. Configure redistribution of Connected routes Configure redistribution of Kernel routes Configure redistribution of OSPF routes Configure redistribution of RIP routes Configure redistribution of Static routes 1093