D-Link DXS-5000-54S Emulator - Page 681

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Example The following is an example of this command. (Routing)(Config)#interface 0/1 (Routing)(Interface 0/1)# (Routing)(Interface 0/1)#ip policy route-map equal-access In order to disable policy based routing from an interface, use no form of this command no ip policy 7-51 ip prefix-list To create a prefix list or add a prefix list entry, use the ip prefix-list command in Global Configuration mode. Route prefixes are matched with those specified in the prefix list. Each prefix list includes a sequence of entries ordered by sequence numbers. A router sequentially examines each prefix list entry to determine if the route's prefix matches that of the entry. An empty or nonexistent prefix list permits all prefixes. An implicit deny is assumed if a given prefix does not match any entries of a prefix list. Once a match or deny occurs the router does not go through the rest of the list. A prefix list may be used within a route map to match a route's prefix using the command. Up to 128 prefix lists may be configured. The maximum number of statements allowed in a prefix list is 64. No command deletes a prefix list or a statement in a prefix list. The command no ip prefix-list list-name deletes the entire prefix list. To remove an individual statement from a prefix list, you must specify the statement exactly, with all its options. ip prefix-list list-name {[seq number] {permit | deny} network/length [ge length] [le length] | renumber renumber-interval first-statement-number} no ip prefix-list list-name [seq number] {permit | deny} network/length [ge length] [le length] Parameters list-name seq number permit deny network/length ge length Text name of the prefix list. Up to 32 characters. (Optional) Sequence number for the prefix list statement. Prefix list statements are ordered from lowest to highest sequence number and applied in that order. If you do not specify a sequence number, the system automatically selects a sequence number five units larger than the last sequence number in the list. Two statements may not be configured with the same sequence number. The value ranges from 1 to 4,294,967,294. Permit routes whose destination prefix matches the statement. Deny routes whose destination prefix matches the statement. Specifies the match criteria for routes being compared to the prefix list statement. The network can be any valid IP prefix. The length is any IPv4 prefix length from 0 to 32. (Optional) If this option is configured, then a prefix is only considered a match if its network mask length is greater than or equal to this value. This value must be longer than the network length and less than or equal to 32. 675