D-Link DXS-5000-54S Emulator - Page 1211

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide no acl-trapflags Parameters None Default The default is Disabled. Command Mode Global Config 12-79 show ip access-lists Use this command to view summary information about all IP ACLs configured on the switch. To view more detailed information about a specific access list, specify the ACL number or name that is used to identify the IP ACL. For ACL with multiple rules, once a match occurs at any one specific rule, counters associated with this rule only get incremented for example,consider an ACL with three rules, after matching rule two, counters for rule three would not be incremented). For ACL counters, if an ACL rule is configured without RATE-LIMIT, the counter value is count of forwarded/discarded packets (for example: If burst of 100 packets sent from IXIA, the Counter value is 100). If an ACL rule is configured with RATE LIMIT, the counter value will be the MATCHED packet count. If the sent traffic rate exceeds the configured limit, counters will still display matched packet count (despite getting dropped beyond the configured Iimit since match criteria is met) that would equal the sent rate. For example, if rate limit is set to 10 kbps and 'matching' traffic is sent at 100 kbps, counters would reflect 100 kbps value. If the sent traffic rate is less than the configured limit, counters would display only matched packet count. Either way, only matched packet count is reflected in the counters, irrespective of whether they get dropped or fonivarded. ACL counters do not interact with diffserv policies. show ip access-lists [1-199 | name] Parameters 1-199 name Displays the ACL ID used to identify a specific IP ACL. Displays the ACL name used to identify a specific IP ACL. Default The default is None. Command Mode Privileged EXEC Example The following shows example CLI display output for the command. (Routing)#show ip access-lists ip1 1205