D-Link DXS-5000-54S Emulator - Page 1256

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide O/S Support Table 60: Linux BSP Log Message Component Linux BSP Message rc=10 Cause Second message logged at bootup, right after Starting code.... Always logged. Table 61: OSAPI Linux Log Messages Component OSAPI Linux OSAPI Linux OSAPI Linux OSAPI Linux OSAPI Linux OSAPI Linux OSAPI Linux OSAPI Linux OSAPI Linux OSAPI Linux Message Cause osapiNetLinkNeighDump: could not open socket! - or - ipstkNdpFlush: could not open socket! - or - osapiNetlinkDumpOpen: unable to bind socket! errno = XX ipstkNdpFlush: sending delete failed osapimRouteEntryAdd, errno XX adding 0xYY to ZZ - or - osapimRouteEntryDelete, errno XX deleting 0xYY from ZZ l3intfAddRoute: Failed to Add Route - or - l3intfDeleteRoute: Failed to Delete Route osapiNetlfConfig: ioctl on XX failed: addr: 0xYY, err: ZZ - or - osapiNetlPSet: ioctl on XX failed: addr:0x%YY Ping: sendto error Failed to Create Interface TAP Unable to open XX Tap monitor task is spinning on select failures - then - Tap monitor select failed: XX Log_lnit: log file error - creating new log file Couldn't open a netlink socket. Make sure "ARP Daemon support" (CONFIG_ARPD) is enabled in the Linux kernel, if the reference kernel binary is not being used. Failed when telling the kernel to delete a neighbor table entry (the message is incorrect). Error adding or deleting an IPv4 route (listed In hex as YY), on the interface with Linux name ZZ Error code can be looked up in errno.h. Error adding or deleting a default gateway in the kernel's routing table (the function is really osapiRawMRouteAdd()/Delete()). Failed trying to set the IP address (in hex as YY) of the interface with Linux name XX, and the interface does not exist. Sometimes this is a harmless race condition (e.g., we try to set address 0 when DHCPing on the network port (dtl0) at bootup, before it's created using TAP). Trouble sending an ICMP echo request packet forthe Ul ping command. Maybe there was no route to that network. Out of memory at system initialization time. The/dev/tap file is missing, or, if not using the reference kernel binary, the kernel is missing "Universal TUN/TAP device driver support" (CONFlG_TUN). Trouble reading the/dev/tap device, check the error message XX for details. This pertains to the "event log" persistent file in flash. Either it did not exist, or had a bad checksum. 1250