D-Link DXS-5000-54S Emulator - Page 926

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Parameters None Default The default is Disabled. Command Mode Interface Config 8-153 ipv6 dhcp snooping limit Controls the rate at which the DHCP Snooping messages arrive at a specific interface or a range of interfaces. Rate limiting is disabled by default. When rate limiting is enabled, the allowable rate can range from 0 to as high as 300 packets per second. The allowed range for the burst level is 1 to 15 seconds. The configuration of rate limiting occurs on a physical port, and it may be applied to both trusted and untrusted ports. The no command resets the rate at which the DHCP Snooping messages arrive, as well as the burst level, to the default values. ipv6 dhcp snooping limit {rate 0-300 [burst interval seconds]} no ipv6 dhcp snooping limit Parameters rate burst interval seconds Configure rate limit in pps (0-300). (Optional) Indicates the burst interval in seconds. Default The default is Disabled (no limit). Command Mode Interface Config 8-154 ipv6 verify source Configures the lPv6SG source ID attribute so that it filters the data traffic in the hardware. The source ID consists of a combination of the IP address and MAC address. Normal command makes data traffic filtration based on the IP address possible. With the "port-security" option, meanwhile, the filtering of data traffic is conducted based on the IP and MAC addresses. Please note that this command can be used to configure either a specific interface or a range of interfaces. The no command disables the IPv6SG configuration in the hardware. The port-security cannot be disabled alone if it is configured. 920