D-Link DXS-5000-54S Emulator - Page 881

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide no ipv6 ospf mtu-ignore Parameters None Default The default is Enabled. Command Mode Interface Config 8-99 ipv6 ospf network Changes the default OSPF network type for a specific interface or a range of interfaces. The network type is normally determined according to the physical IP network type, and all Ethernet networks are, by default, OSPF type broadcast. Similarly, the default type for tunnel interfaces is point-to-point. When an Ethernet port is utilized as a single large bandwidth IP network in between two routers, then the network type may be point-to-point since only two routers are invlovled. The use of point-to-point as the network type eliminates the overhead of the OSPF designated router selection. It is not useful under normal circumstances to set a tunnel to OSPF network type broadcast. The no command resets the interface type back to the default value. ipv6 ospf network {broadcast | point-to-point} no ipv6 ospf network {broadcast | point-to-point} Parameters broadcast point-to-point Default The default is Broadcast. Command Mode Interface Config Set OSPFv3 Interface Type to Broadcast. Set OSPFv3 Interfcae Type to Point to Point. 8-100 ipv6 ospf prefix-suppression Suppresses the advertisement of those IPv6 prefixes that are associated with a given interface, with the exception of those associated with secondary IPv6 addresses. Use of this command takes precedence over the global configuration. If the configuration is not specified, however, then the global prefixsuppression configuration applies. 875