D-Link DXS-5000-54S Emulator - Page 664

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide Prefix List In Prefix List Out Neighbors OSPFv2 Section: Routing Protocol Router ID OSPF Admin Mode Maximum Paths Routing for Networks Distance Default Route Advertise Always Metric Metric Type Redist Source Metric Metric Type Subnets Dist List Number of Active Areas ABR Status ASBR Status Global prefix list used to filter inbound routes from all neighbors. Global prefix list used to filter outbound routes to all neighbors. List of configured neighbors and the inbound and outbound policies configured for each. OSPFv2. The router ID configured for OSPFv2. Indicates whether OSPF is enabled or disabled globally. Maximum number of next hops in an OSPF route. Address ranges configured with an OSPF network command. Administrative distance (or "route preference") for intra-area, inter-area, and external routes. Indicates whether OSPF is configured to originate a default route. Indicates whether default advertisement depends on having a default route in the common routing table. The metric configured to be advertised with the default route. The metric type for the default route. A type of routes that OSPF is redistributing. The metric to advertise for redistributed routes of this type. The metric type to advertise for redistributed routes of this type. Indicates whether OSPF redistributes subnets of classful addresses, or only classful prefixes. A distribute list used to filter routes of this type. Only routes that pass the distribute list are redistributed. The number of OSPF areas with at least one interface running on this router. Also broken down by area type. Indicates whether the router is currently an area border router. A router is an area border router if it has interfaces that are up in more than one area. Indicates whether the router is an autonomous system boundary router. The router is an ASBR if it is redistributing any routes or originating a default route. 7-38 show ip route Display the routing table for the specified virtual router (vrf vrf-name). If no router is specified, the default router routing table is displayed. The ip-address specifies the network for which the route is to be displayed and displays the best matching best-route for the address. The mask specifies the subnet mask for the given ip-address. When you use the longer-prefixes keyword, the ip-address and mask pair becomes the prefix, and the command displays the routes to the addresses that match that prefix. Use the protocol parameter to specify the protocol that installed the routes. The value for protocol can be ospf, 658