D-Link DXS-5000-54S Emulator - Page 173

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide 810 hapiRxTask 0.00% 0.01% 0.01% 805 dtlTask 0.00% 0.02% 0.02% 863 spmTask 0.00% 0.01% 0.00% 894 ip6MapLocalDataTask 0.00% 0.01% 0.01% 908 RMONTask 0.00% 0.11% 0.12% Total CPU Utilization 1.55% 1.58% 1.50% 5-31 show running-config This command is used to show or record the current settings of different protocol packages supported on the switch. More specifically, it displays or records those commands with settings and configurations that are different from the default values. To display or record those commands with settings and configurations that remain equal to the default value, simply include the all option. It should be noted that the Show running-config command does not show the User Password, even if one different from the default has been set. The output for the command is displayed in script format, and the output can then be used to configure another switch with the same configuration. The output will be redirected to a script file if the optional scriptname is provided with a file name extension of ".scr". Note: If the show running-config command is issued from a serial connection, access to the switch via remote connections (such as Telnet) will be suspended as the output is being generated and shown. Note: If a text-based configuration file is used, then the show running-config command will only show the configured physical interfaces. That is, if any interface contains only the default configuration, then that interface will be skipped when generating the show running-config command output. (This is true, in fact, for any configuration mode for which nothing but the default configuration is used.) In other words, the command to enter a particular config mode, as well as its exit command, are both omitted from the generated show running-config command output. As a result, they are omitted from the startup-config file when the configuration for the system is saved. The following keys should be used to navigate the command output. Key Enter Space Bar q Action Advances one line. Advances one page. Stops the output and returns to the prompt. It should be noted that --More-- or (q)uit is shown at the bottom of the output screen until the user reaches the end of the output. This command is used to display the current settings for the OSPFv2 trapflag status: • ln the event that all the flags are enabled, then trapflags all will be displayed by the command. • ln the event that all the flags in a specific group are enabled, then the command will cause the trapflags group name all to be displayed. • If only some but not all of the flags in said group are enabled, the command will cause the trapflags groupname flag-name to be displayed. show running-config [all | interface | vpc | scriptname] 167