D-Link DXS-5000-54S Emulator - Page 775

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide LSA Refresh Group Pacing Time Opaque Capability Autocost Ref BW Default Passive Setting Prefix suppression Maximum Paths Maximum routes Default Metric Stub Router Configuration Stub Router Startup Time Summary LSA Metric Override BFD Enabled Default Route Advertise Always Metric Metric Type Number of Active Areas ABR Status ASBR Status Stub Router Status Stub Router Reason Stub Router Startup Time Remaining on an interface. This is the value configured with the command "timers pacing flood". Size in seconds of the LSA refresh group window. This is the value configured with the command "timers pacing Isa-group". Shows whether the router is capable of sending Opaque LSAs. Shows the value of auto-cost reference bandwidth configured on the router. Shows whether the interfaces are passive by default. Displays whether the prefix-suppression is enabled or disabled. Maximum number of paths that OSPF can report for a given destination. Shows the maximum IPv6 route table size. Default value for redistributed routes. When OSPF runs out of resources to store the entire link state database, or any other state information, OSPF goes into stub router mode. As a stub router, OSPF reoriginates its own router LSAs, setting the cost of all nonstub interfaces to infinity. Use this field to set stub router configuration to one of Always, Startup, None. Displays the remaining time, in seconds, until OSPF exits stub router mode. The parameter is listed once OSPF is in startup stub router mode. One of Enabled (met), Disabled, where met is the metric to be sent in summary LSAs when in stub router mode. Displays the BFD status. Indicates whether the default routes received from other source protocols are advertised or not. Shows whether default routes are always advertised. Metric of the routes being redistributed. If the metric is not configured, this field is blank. Shows whether the routes are External Type 1 or External Type 2. Number of active OSPF areas. An "active" OSPF area is an area with at least one interface up. Shows whether the router is an OSPF Area Border Router. Reflects whether the ASBR mode is enabled or disabled. Enable implies that the router is an autonomous system border router. The router automatically becomes an ASBR when it is configured to redistribute routes learned from other protocols. The possible values for the ASBR status is enabled (if the router is configured to redistribute routes learned by other protocols) or disabled (if the router is not configured for the same). One of Active, Inactive. One of Configured, Startup, Resource Limitation. Note: The row is only listed if stub router is active. Remaining time, in seconds, until OSPF exits stub router mode. This row is only listed if OSPF is in startup stub router mode. 769