Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 134

www.dell.com | support.dell.com Configuring DCBX Operation The data center bridging exchange protocol (DCBX) is used by DCB devices to exchange configuration information with directly connected peers using the link layer discovery protocol (LLDP) protocol. DCBX can detect the misconfiguration of a peer DCB device, and optionally, configure peer DCB devices with DCB feature settings to ensure consistent operation in a data center network. DCBX is a prerequisite for using DCB features, such as priority-based flow control (PFC) and enhanced traffic selection (ETS), to exchange link-level configurations in a converged Ethernet environment. DCBX is also deployed in topologies that support lossless operation for FCoE or iSCSI traffic. In these scenarios, all network devices are DCBX-enabled (DCBX is enabled end-to-end). For more information about how these features are implemented and used on an MXL Switch, refer to: • Configuring Priority-Based Flow Control • Configuring Enhanced Transmission Selection • FIP Snooping • iSCSI Optimization The following versions of DCBX are supported on an MXL Switch: CIN, CEE, and IEEE2.5. Prerequisite: DCBX requires the LLDP to be enabled on all DCB devices. DCBX Operation DCBX performs the following operations: • Discovers DCB configuration (such as PFC and ETS) in a peer device. • Detects DCB misconfiguration in a peer device; that is, when DCB features are not compatibly configured on a peer device and the local switch. Misconfiguration detection is feature-specific because some DCB features support asymmetric configuration. • Reconfigures a peer device with the DCB configuration from its configuration source if the peer device is willing to accept configuration. • Accepts the DCB configuration from a peer if a DCBX port is in "willing" mode to accept a peer's DCB settings and then internally propagates the received DCB configuration to its peer ports. 132 | Data Center Bridging (DCB)