Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 378

www.dell.com | support.dell.com To change OSPFv2 parameters on the interfaces, use any or all of the following commands in CONFIGURATION INTERFACE mode. Command Syntax ip ospf cost ip ospf dead-interval seconds ip ospf hello-interval seconds ip ospf message-digest-key keyid md5 key ip ospf priority number ip ospf retransmit-interval seconds ip ospf transmit-delay seconds Command Mode Usage CONFIG-INTERFACE Change the cost associated with OSPF traffic on the interface. Cost: 1 to 65535 (default depends on the interface speed). CONFIG-INTERFACE Change the time interval the router waits before declaring a neighbor dead. Configure Seconds range: 1 to 65535 (default is 40 seconds). The dead interval must be four times the hello interval. The dead interval must be the same on all routers in the OSPF network. CONFIG-INTERFACE Change the time interval between the hello-packet transmission. Seconds range: from 1 to 65535 (default is 10 seconds). The hello interval must be the same on all routers in the OSPF network. CONFIG-INTERFACE Use the MD5 algorithm to produce a message digest or key, which is sent instead of the key. Keyid range: 1 to 255 Key: a character string Be sure to write down or otherwise record the Key. You cannot learn the key once it is configured. You must be careful when changing this key. CONFIG-INTERFACE Change the priority of the interface, which is used to determine the designated router for the OSPF broadcast network. Number range: 0 to 255 (the default is 1). CONFIG-INTERFACE Change the retransmission interval between the LSAs. Seconds range: from 1 to 65535 (default is 5 seconds). The retransmit interval must be the same on all routers in the OSPF network. CONFIG-INTERFACE Change the wait period between the link state update packets sent out the interface. Seconds range: from 1 to 65535 (default is 1 second). The transmit delay must be the same on all routers in the OSPF network. 376 | Open Shortest Path First (OSPFv2)