Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 444

www.dell.com | support.dell.com The show ip protocols command example Figure 25-5 confirms that both versions are sent out that interface. This interface no longer sends and receives the same RIP versions as FTOS does globally. Figure 25-5. show ip protocols Command Example FTOS#show ip protocols Routing Protocols is RIP Sending updates every 30 seconds, next due in 11 Invalid after 180 seconds, hold down 180, flushed after 240 Output delay 8 milliseconds between packets Automatic network summarization is in effect Outgoing filter for all interfaces is Incoming filter for all interfaces is Default redistribution metric is 1 Default version control: receive version 2, send version 2 RIPv2 configured Interface Recv Send globally Tengigabitethernet 0/0 2 1 2 Different RIP versions Routing for Networks: configured for this 10.0.0.0 interface Routing Information Sources: Gateway Distance Last Update Distance: (default is 120) FTOS# Generate a Default Route When the traffic's network is not explicitly listed in the routing table, traffic is forwarded to the default route. Default routes are not enabled in RIP unless specified. To generate a default route into RIP, use the default-information originate command in ROUTER RIP mode. In FTOS, default routes received in RIP updates from other routes are advertised if you configured the default-information originate command. To configure FTOS to generate a default route, use the following command in ROUTER RIP mode: Command Syntax default-information originate [always] [metric value] [route-map route-map-name] Command Mode ROUTER RIP Purpose Specify the generation of a default route in RIP. Configure the following parameters: • always: enter this keyword to always generate a default route. • value range: 1 to 16. • route-map-name: name of a configured route map. To confirm that the default route configuration is completed, use the show config command in ROUTER RIP mode. 442 | Routing Information Protocol (RIP)