Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 263

Step 3 Command Syntax ip address ip-address mask [secondary] Command Mode INTERFACE Purpose Configure a primary IP address and mask on the interface. • ip-address mask: IP address must be in dotted decimal format (A.B.C.D) and the mask must be in slash prefix-length format (/24). • Add the keyword secondary if the IP address is the interface's backup IP address. To view the configuration, use the show config command (Figure 13-1) in INTERFACE mode or the show ip interface command in EXEC privilege mode (Figure 13-2). Figure 14-1. show config Command Example FTOS(conf-if-te-0/16)#show conf ! interface TenGigabitEthernet 0/16 no ip address shutdown FTOS(conf-if-te-0/16)# Figure 14-2. show ip interface Command Example FTOS#show ip interface tengig 0/16 TenGigabitEthernet 0/16 is down, line protocol is down Internet address is not set IP MTU is 1500 bytes Directed broadcast forwarding is disabled Proxy ARP is enabled Split Horizon is enabled Poison Reverse is disabled ICMP redirects are not sent ICMP unreachables are not sent FTOS# Configure Static Routes A static route is an IP address that is manually configured and not learned by a routing protocol, such as open shortest path first (OSPF). Often static routes are used as backup routes in case other dynamically learned routes are unreachable. To configure a static route, use the following command in CONFIGURATION mode: IPv4 Routing | 261