Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 511

Show sFlow on a Stack Unit To view sFlow statistics on a specified stack unit, use the following command (Figure 29-4): Command Syntax show sflow stack-unit unit-number Command Mode Purpose EXEC Display sFlow configuration information and statistics on the specified interface. Figure 29-4. show sflow stack unit Command Example FTOS#show sflow stack-unit 1 Stack-Unit 1 Samples rcvd from h/w :0 Total UDP packets exported :0 UDP packets exported via RPM :0 UDP packets dropped :0 FTOS# Specify Collectors The sflow collector command allows identification of sFlow collectors to which sFlow datagrams are forwarded. You can specify up to two sFlow collectors. If you specify two collectors, the samples are sent to both. To identify sFlow collectors, use the following command: Command Syntax sflow collector ip-address agent-addr ip-address [number [max-datagram-size number] ] | [max-datagram-size number ] Command Mode CONFIGURATION Usage Identify sFlow collectors to which sFlow datagrams are forwarded. Default UDP port: 6343 Default max-datagram-size: 1400 Polling Intervals The sflow polling-interval command configures the polling interval for an interface in the maximum number of seconds between successive samples of counters to be sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can configure an interface to use a different polling interval. You can configure the polling interval globally (in CONFIGURATION mode) or by interface (in INTERFACE mode) by executing the following interval command: sFlow | 509