Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 584

www.dell.com | support.dell.com To confirm that a port is participating in STP, use the show spanning-tree 0 brief command from EXEC privilege mode (Figure 33-6). Figure 33-6. show spanning-tree brief Command Example FTOS#show spanning-tree 0 brief Executing IEEE compatible Spanning Tree Protocol Root ID Priority 32768, Address 0001.e80d.2462 We are the root of the spanning tree Root Bridge hello time 2, max age 20, forward delay 15 Bridge ID Priority 32768, Address 0001.e80d.2462 Configured hello time 2, max age 20, forward delay 15 Bpdu filter disabled globally Interface Name Tengig 1/1 Tengig 1/2 Tengig 1/3 Tengig 1/4 FTOS# Designated PortID Prio Cost Sts Cost Bridge ID PortID 8.496 8 4 DIS 0 32768 0001.e80d.2462 8.496 8.497 8 4 DIS 0 32768 0001.e80d.2462 8.497 8.513 8 4 FWD 0 32768 0001.e80d.2462 8.513 8.514 8 4 FWD 0 32768 0001.e80d.2462 8.514 Adding an Interface to the Spanning Tree Group To add a Layer 2 interface to the STP topology, use the following command: Task Enable spanning tree on a Layer 2 interface. Command Syntax spanning-tree 0 Command Mode INTERFACE Removing an Interface from the Spanning Tree Group To remove a Layer 2 interface from the STP topology, use the following command: Task Disable spanning tree on a Layer 2 interface. Command Syntax no spanning-tree 0 Command Mode INTERFACE 582 | Spanning Tree Protocol (STP)