Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 293

To configure the LACP long timeout, follow the step below. Step 1 Task Set the LACP timeout value to 30 seconds. Command Syntax lacp long-timeout Figure 16-4 shows the no shutdown command. Command Mode CONFIG-INT-PO Figure 16-4. Invoking the LACP Long Timeout FTOS(conf)# interface port-channel 32 FTOS(conf-if-po-32)#no shutdown FTOS(conf-if-po-32)#switchport FTOS(conf-if-po-32)#lacp long-timeout FTOS(conf-if-po-32)#end FTOS# show lacp 32 Port-channel 32 admin up, oper up, mode lacp Actor System ID: Priority 32768, Address 0001.e800.a12b Partner System ID: Priority 32768, Address 0001.e801.45a5 Actor Admin Key 1, Oper Key 1, Partner Oper Key 1 LACP LAG 1 is an aggregatable link A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC I - Collection enabled, J - Collection disabled, K - Distribution enabled L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state, P - Receiver is not in expired state Port TenGig 10/6 is enabled, LACP is enabled and mode is lacp Actor Admin: State ADEHJLMP Key 1 Priority 128 Note: To view PDU exchanges and the timeout value, use the debug lacp command. For more information, refer to Monitor and Debugging LACP. Monitor and Debugging LACP The system log (syslog) records faulty LACP actions. To debug LACP, use the following command: Command Syntax Command Mode [no] debug lacp [config | events | pdu [in | EXEC out | [interface [in | out]]]] Purpose Debug LACP, including configuration and events. Link Aggregation Control Protocol (LACP) | 291