Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 65

Configure FTP Client Parameters To configure FTP client parameters, use the following commands in CONFIGURATION mode: Command Syntax ip ftp source-interface interface ip ftp password password ip ftp username name Command Mode CONFIGURATION CONFIGURATION CONFIGURATION Purpose Enter the following keywords and slot/port or number information: • For a loopback interface, enter the keyword loopback followed by a number between 0 and 16383. • For a port channel interface, enter the keyword port-channel followed by a number from 1 to 128 For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Configure a password. Enter username to use on FTP client. To view FTP configuration, use the show running-config ftp command in EXEC privilege mode (Figure 4-4). Terminal Lines You can access the system remotely and restrict access to the system by creating user profiles. The terminal lines on the system provide different means of accessing the system. The virtual terminal lines (VTY) connect you through Telnet to the system. Deny and Permit Access to a Terminal Line Dell Force10 recommends applying only standard access control lists (ACLs) to deny and permit access to VTY lines. • Layer 3 ACL deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny any traffic. • You cannot use the show ip accounting access-list command to display the contents of an ACL that is applied only to a VTY line. To apply an IP ACL to a line: Task Apply an ACL to a VTY line. Command Syntax ip access-class access-list Command Mode LINE To view the configuration, enter the show config command in LINE mode (Figure 4-5). Management | 63