Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 630

www.dell.com | support.dell.com To tag frames leaving an interface in Layer 2 mode, you must assign that interface to a port-based VLAN to tag it with that VLAN ID. To tag interfaces, follow these steps: Step Command Syntax 1 interface vlan vlan-id 2 tagged interface Command Mode CONFIGURATION INTERFACE Purpose Access INTERFACE VLAN mode of the VLAN to which you want to assign the interface. Enable an interface to include the IEEE 802.1Q tag header. Figure 37-4 shows the steps to add a tagged interface (in this case, port channel 1) to VLAN 4. Figure 37-4. Example of Adding an Interface to Another VLAN FTOS#show vlan Codes: * - Default VLAN, G - GVRP VLANs NUM Status Q Ports * 1 Inactive 2 Active T Po1(So 0/0-1) T Tengig 3/0 3 Active T Po1(So 0/0-1) T Tengig 3/1 FTOS#config FTOS(conf)#int vlan 4 FTOS(conf-if-vlan)#tagged po 1 FTOS(conf-if-vlan)#show conf ! interface Vlan 4 no ip address tagged Port-channel 1 FTOS(conf-if-vlan)#end FTOS#show vlan Codes: * - Default VLAN, G - GVRP VLANs NUM * 1 2 3 4 FTOS# Status Inactive Active Active Active Q Ports T Po1(So 0/0-1) T Tengig 3/0 T Po1(So 0/0-1) T Tengig 3/1 T Po1(So 0/0-1) Use the show vlan command to view the interface's status. Interface (po 1) is tagged and in VLAN 2 and 3 In a port-based VLAN, use the tagged command to add the interface to another VLAN. The show vlan command output displays the interface's (po 1) changed status. 628 | Virtual LANs (VLAN)