Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 43

Figure 3-3. Completed Boot Process (Contd.) DRAM: 2 GB Initialized CPLD on CS3 Detected [XLP308 (Lite+) Rev A0] Initializing I2C0: speed = 30 KHz, prescaler = 0x0377 -- done. Initializing I2C1: speed = 100 KHz, prescaler = 0x0109 -- done. Initialized eMMC Host Controller Detected SD Card Now running in RAM - U-Boot [N64 ABI, Big-Endian] at: ffffffff8c100000 Flash: 256 MB PCIE (B0:D01:F0) : Link up. PCIE (B0:D01:F1) : No Link. In: serial Out: serial Err: serial Net: nae-0: PHY is Broadcom BCM54616S --More-SOFTWARE IMAGE HEADER DATA More-Starting Dell Force10 application Welcome to Dell Easy Setup Wizard The setup wizard guides you through the initial switch configuration, and gets you up and running as quickly as possible. You can skip the setup wizard, and enter CLI mode to manually configure the switch. You must respond to the next question to run the setup wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration. Note: You can exit the setup wizard at any point by entering [ctrl+c]. Would you like to run the setup wizard (you must answer this question within 60 seconds)? [Y/N]: N 00:00:40: %STKUNIT0-M:CP %IFMGR-5-ASTATE_UP: Changed interface Admin state to up: Vl 1 00:00:42: %STKUNIT0-M:CP %IFMGR-5-IFM_ISCSI_ENABLE: iSCSI has been enabled causing flow control to be enabled on all interfaces. EQL detection and enabling iscsi profile-compellent on an interface may cause some automatic configurations to occur like jumbo frames on all ports and no storm control and spanning tree port-fast on the port of detection 00:00:42: %STKUNIT0-M:CP %SEC-5-LOGIN_SUCCESS: Login successful for user on line console FTOS>en Password: Getting Started | 41