Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 446

www.dell.com | support.dell.com To view configuration changes, use the show config command in ROUTER RIP mode. Debug RIP To enable RIP debugging, use the debug ip rip command. When you enable debugging, you can view information about RIP protocol changes or RIP routes (Figure 25-6). To enable RIP debugging, use the following command in EXEC privilege mode: Command Syntax debug ip rip [interface | database | events | trigger] Command Mode EXEC privilege Figure 25-6. debug ip rip Command Example FTOS#debug ip rip RIP protocol debug is ON FTOS# Purpose Enable debugging of RIP. To disable RIP, use the no debug ip rip command. RIP Configuration Example The example in this section shows the command sequence to configure RIPv2 on the two routers shown in Figure 25-7-"Core 2" and "Core 3". The host prompts used in the example reflects those names. The examples are divided into the following groups of command sequences: • Configuring RIPv2 on Core 2 • Core 2 Output • RIP Configuration on Core 3 • Core 3 RIP Output • RIP Configuration Summary 444 | Routing Information Protocol (RIP)