Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 439

• Generate a Default Route (optional) • Control Route Metrics (optional) • Summarize Routes (optional) • Control Route Metrics • Debug RIP For a complete listing of all commands related to RIP, refer to the FTOS Command Reference Guide. Enable RIP Globally By default, RIP is not enabled in FTOS. To enable RIP, use the following commands in sequence, starting in CONFIGURATION mode: Step Command Syntax 1 router rip 2 network ip-address Command Mode CONFIGURATION ROUTER RIP Purpose Enter ROUTER RIP mode and enable the RIP process on FTOS. Assign an IP network address as a RIP network to exchange routing information. You can use this command multiple times to exchange RIP information with as many RIP networks as you want. After designating the networks that the system is to exchange RIP information, ensure that all devices on that network are configured to exchange RIP information. The FTOS default is to send RIPv1, and to receive RIPv1 and RIPv2. To change the RIP version globally, use the version command in ROUTER RIP mode. After you enable RIP, to view the global RIP configuration, use the show running-config command in EXEC mode or the show config command (Figure 25-1) in ROUTER RIP mode. Figure 25-1. show config Command Example (ROUTER RIP Mode) FTOS(conf-router_rip)#show config ! router rip network 10.0.0.0 FTOS(conf-router_rip)# Routing Information Protocol (RIP) | 437