Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 242

www.dell.com | support.dell.com Figure 13-17. Interface Range Prompt Excluding Duplicate Entries FTOS(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3 FTOS(conf-if-range-vl-1,vl-3)# FTOS(conf)#interface range tengigabitethernet 2/0 - 23 , tengigabitethernet 2/0 - 23 , tengigab 2/0 - 23 FTOS(conf-if-range-te-2/0-23)# Exclude a Smaller Port Range If the interface range has multiple port ranges, the smaller port range is excluded from the prompt. Figure 13-18. Interface Range Prompt Excluding a Smaller Port Range FTOS(conf)#interface range tengigabitethernet 2/0 - 23 , tengigab 2/1 - 10 FTOS(conf-if-range-te-2/0-23)# Overlap Port Ranges If overlapping port ranges are specified, the port range is extended to the smallest start port number and largest end port number. Figure 13-19. Interface Range Prompt Including Overlapping Port Ranges FTOS(conf)#inte ra tengig 2/1 - 11 , tengig 2/1 - 23 FTOS(conf-if-range-te-2/1-23)# Commas The example below shows how to use commas to add different interface types to the range, enabling all Ten Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/ 2. Figure 13-20. Multiple-Range Bulk Configuration Gigabit Ethernet and Ten-Gigabit Ethernet FTOS(conf-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2 FTOS(conf-if-range-te-5/1-23)# no shutdown FTOS(conf-if-range-te-5/1-23)# Add Ranges The example below shows how to use commas to add VLAN and port-channel interfaces to the range. 240 | Interfaces