Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module Configuration Guide - Page 236

www.dell.com | support.dell.com • ip mtu (if the interface is on a Jumbo-enabled by default.) Note: The MXL Switch supports jumbo frames by default (the default maximum transmission unit [MTU] is 1554 bytes) You can configure the MTU using the mtu command from INTERFACE mode. To view the interface's configuration, enter INTERFACE mode for that interface and use the show config command or from EXEC Privilege mode, use the show running-config interface interface command. To add a physical interface to a port channel, use these commands in the following sequence in INTERFACE mode of a port channel: Step Command Syntax 1 channel-member interface 2 show config Command Mode INTERFACE PORT-CHANNEL INTERFACE PORT-CHANNEL Purpose Add the interface to a port channel. The interface variable is the physical interface type and slot/port information. Double check that the interface was added to the port channel. To view the port channel's status and channel members in a tabular format, use the show interfaces port-channel brief command in EXEC Privilege mode (Figure 13-10). Figure 13-10. show interfaces port-channel brief Command Example FTOS#show int port brief Codes: L - LACP Port-channel LAG Mode Status 1 L3 down FTOS# Uptime 00:00:00 Ports Te 0/16 (Down) 234 | Interfaces